To fix connection and login issues with the AirLive WL-1134ARM Go to product viewer dialog for this item.
web-based setup utility, follow these step-by-step diagnostic and recovery instructions. 1. Verify Physical and LED Status
Check LAN Connection: Ensure your PC connects directly to one of the router’s LAN ports via an Ethernet cable. Avoid using Wi-Fi for initial configuration troubleshooting.
Inspect Link LEDs: Confirm that the Power LED and the corresponding LAN Port LED on the router’s front panel are lit green or flashing. A dark LAN LED indicates a bad cable or a faulty network card. 2. Configure Your PC’s IP Address
The most common cause of utility connection failure is an IP subnet mismatch. The Default Gateway: The AirLive WL-1134ARM Go to product viewer dialog for this item.
typically uses the default IP address 192.168.1.1 or 192.168.1.254.
Set Static IP: If your PC fails to pull an IP automatically via DHCP, you must manually change your computer’s IPv4 settings.
IP Details: Assign your PC a static IP address of 192.168.1.10 and a Subnet Mask of 255.255.255.0. Leave the Default Gateway field empty during setup. 3. Clear Browser and Utility Blocks
Use HTTP: Type the full address http://192.168.1.1 (or http://192.168.1.254) directly into the browser address bar. Do not use https:// as older legacy hardware utility software does not support modern SSL/TLS certificates.
Inprivate Browsing: Open an Incognito window to bypass corrupt local cache files or cookies causing loop errors.
Disable Proxies: Turn off any active VPNs or proxy configurations in your browser settings. 4. Bypass the Login Screen
If the setup utility prompt appears but rejects your credentials, use the factory default combinations: AirLive WL-5460AP v2 User Manual
Leave a Reply